A model for hydraulic design of irrigation lateral lines
DOI:
https://doi.org/10.13083/reveng.v28i.936Palavras-chave:
pressure loss, energy conservation, mass conservationResumo
There are several models for hydraulic designs and optimization of lateral lines depending on the existing pressure head profile and flow which allows designing longer lateral lines, therefore decreasing the cost of the system implementation. A model has been developed to calculate the pressure head and required flow rate at the inlet of lateral line using the back step method. A set of equations was implemented in an algorithm in the R language. For the calculations, the following variables must be provided: pressure head at the end of the lateral line (Hend), coefficients K and x of the characteristic equation (flow-pressure) of the emitter, pipe diameter (D), emitter spacing (Se) and number of emitters (Ne). For the evaluation of the model, the pressure head at the end of the lateral line, the pipe diameter and the number of emitters were varied within the established limits. Relationships between these variables were established by regression analysis using the least-squares method. The model shown in the study was suitable for the calculation of the pressure head and flow rate profile along the lateral line. The power, plateau, exponential and linear equations were adjusted to describe these relationships. These equations can help in the design of irrigation systems by simplifying the procedures in order to meet the design criteria. Also, the proposed equations allow evaluation of the systems still in the design phase.
Downloads
Referências
AYARS, J.E.; BUCKS, D.A.; LAMM, F.R.; NAKAYAMA, F.S. Introduction. In: Lamm, F.R.; Ayars, J.E.; Nakayama, F.S. Microirrigation for crop production, Amsterdam: Elsevier, 2007, cap.1.
BERNARDO, S.; SOARES, A.A.; MANTOVANI, E.C. Manual de Irrigação. Viçosa: UFV, 2011.
BRALTS, V.F.; EDWARDS, D.M.; WU, I.-P. Drip Irrigation Design and Evaluation Based on the Statistical Uniformity Concept. Advances in Irrigation, v. 4, p.67-117, 1987.
CASTIBLANCO, C.J.M. Modelo computacional para o dimensionamento da subunidade em irrigação localizada.2013. 120f. Tese (Doutor em Ciências) – Escola Superior de Agricultura “Luiz de Queiroz”, Universidade de São Paulo, Piracicaba, 2013.
CLARK, G.A.; HAMAN, D.Z.; PROCHASKA, J.F.; YITAYEW, M. General system design principles. In: Lamm, F. R.; Ayars, J. E.; Nakayama, F. S. Microirrigation for crop production, Amsterdam: Elsevier, 2007, cap.5.
IHAKA, R.; GENTLEMAN, R.R: a language for data analysis and graphics. Journal of Computational and Graphical Statistics, v.5, n.3, p.299-314, 1996.
IICA. Instituto Interamericano de Cooperação para a Agricultura A irrigação no Brasil: situação e diretrizes. Brasília: IICA, 2008.
JAIN, S.K.; SINGH, K.K.; SINGH, R.P. Microirrigation Lateral Design using Lateral Discharge Equation. Journal of Irrigation and Drainage Engeering, v.128, n.2, p.125-128, 2002.
KANG, Y.; NISHIYAMA, S. Analysis and Design of Microirrigation Laterals. Journal of Irrigation and Drainage Engineering, v.122, n.2, p.75-82, 1996.
MIZYED, N. Numerical analysis to solve the hydraulics of trickle irrigation units. Irrigation and Drainage Systems, v.16, n.1, p.53-68, 2002.
PANDEY, K.K. Development of Computer Algorithm for a Numerical Model To Optimize the Performance of Multi-Outlet Pressurized Irrigation in Sloping and Non-Sloping Terrains. International Journal of Recent Scientific Research, v.7, n.4, p.10445-10450, 2016.
PEREA, H. et al. Statistical Analysis of Non-Pressure-Compensating and Pressure-Compensating Drip Emitters. Journal of Irrigation and Drainage Engineering, v.139, n.12, p.986-994, dez. 2013.
SADEGHI, S.H. et al. Factor H for the calculation of head loss and sizing of dual-diameter laterals. Journal of Agricultural Science and Technology, v.14, n.SUPPL., p.1555-1565, 2012.
SADEGHI, S.H.; PETERS, R.T.; LAMM, F.R. Design of Zero Slope Microirrigation Laterals: Effect of the Friction Factor Variation. Journal of Irrigation and Drainage Engineering, v.141, n.10, p.1-9, out. 2015.
SOKOL, J., AMROSE, S., NANGIA, V., TALOZI, S., BROWNELL, E., MONTANARO, G., ABU NASER, K., BANY MUSTAFA, K., BAHRI, A., BOUAZZAMA, B., BOUIZGAREN, A., MAZAHRIH, N., MOUSSADEK, R., SIKAOUI, L., WINTER, A.G. Energy Reduction and Uniformity of Low-Pressure Online Drip Irrigation Emitters in Field Tests. Water, v.11, n.6, p.1195, 2019.
VALLESQUINO, P.; LUQUE-ESCAMILLA, P.L. New Algorithm for Hydraulic Calculation in irrigation laterals. Journal of Irrigation and Drainage Engineering, v.127, n.4, p.254-260, 2001.
WU, I.P. An assessment of hydraulic design of micro-irrigation systems. Agric. Water Manage., v.32, 1997.
WU, I.P. An assessment of hydraulic design of micro-irrigation systems. Agricultural Water Management, v.32, n.3, p.275-284, mar. 1997.
YILDIRIM, G. An assessment for hydraulically efficient design of uniformly sloping submain lines. Irrigation and Drainage, v.64, n.2, p.157-168, abr. 2015.
YILDIRIM, G. Computer-Based Analysis of Hydraulic Design Variables for Uniformly Sloping Microirrigation System Laterals. J. Irrig. Drain. Eng., vol.144, n.7, 2015.
YILDIRIM, G. Simplified procedure for hydraulic design of small-diameter plastic pipes. Irrigation and Drainage, v.58, n.2, p.209-233, abr. 2009.
YILDIRIM, G. Total energy loss assessment for trickle lateral lines equipped with integrated in-line and on-line emitters. Irrigation Science, v.28, n.4, p.341-352, 20 maio 2010.
ZELLA, L.; KETTAB, A.; CHASSERIAUX, G. Design of a micro-irrigation system based on the control volume method. Biotechnologie, Agronomie, Société et Environnement, v.10, n.3, p.163-171, 2006.
Downloads
Publicado
Como Citar
Edição
Seção
Licença
Copyright (c) 2020 REVISTA ENGENHARIA NA AGRICULTURA - REVENG
Este trabalho está licenciado sob uma licença Creative Commons Attribution-NonCommercial 4.0 International License.
Autores que publicam nesta revista concordam com os seguintes termos:
O(s) autor(es) autoriza(m) a publicação do texto na da revista;
O(s) autor(es) garantem que a contribuição é original e inédita e que não está em processo de avaliação em outra(s) revista(s);
A revista não se responsabiliza pelas opiniões, ideias e conceitos emitidos nos textos, por serem de inteira responsabilidade de seu(s) autor(es);
É reservado aos editores o direito de proceder a ajustes textuais e de adequação às normas da publicação.
A partir da submissão, o autor estará cedendo integralmente seus direitos patrimoniais da obra à publicação, permanecendo detentor de seus direitos morais (autoria e identificação na obra) e de acordo com a Licença Creative Commons, CC BY-NC.
Esta obra está licenciada com uma Licença 